Connect a Stratux to Garmin Pilot
Traffic, GPS position and attitude from your own receiver in Garmin Pilot - over GDL90, with nothing to type in
Garmin Pilot reads the GDL90 protocol, and that is exactly what a Stratux sends. The receiver unicasts its traffic, GPS and AHRS data to every device that joins its WiFi, so there is no IP address, no port and no pairing code to enter anywhere: join the network, pick Stratux in the app's device list, and the targets appear on the map. The whole job takes about five minutes, and most of it is waiting for the GPS to find satellites.
Before you start
- Garmin Pilot version 10.7 or newer - Stratux has been a selectable device since that release.
- A Stratux with both antennas fitted and a clear view of the sky for the GPS, running the firmware build for where you fly - the EU version in Europe, so the second receiver covers 868 MHz.
- An iPad, iPhone or Android tablet with Garmin Pilot installed and its charts already downloaded - once you are on the Stratux WiFi there is no internet to download them over.
- Only for synthetic vision and an attitude display: an AHRS sensor board fitted in the Stratux. Traffic and GPS work without one.
1. On the Stratux
- 1Power the Stratux up and give it about 90 seconds. The SDR receivers start immediately, but the GPS needs that long for its first fix - and without a fix Garmin Pilot has no position to work from.
- 2Nothing has to be configured for GDL90: the output is on by default and goes to every device that takes a DHCP lease on the Stratux WiFi. Leave the settings alone.
- 3Optional, but worth it once: open the Stratux web interface and check that the GPS shows satellites, that both SDRs are recognised and that your tablet is listed as a connected device.
2. In Garmin Pilot
- 1Join the Stratux WiFi in your tablet's WiFi settings. The network is called "stratux" and carries no password unless you set one yourself.
- 2Open Garmin Pilot and go to the connected-devices list (Home - Settings - Connext / Devices). Stratux shows up within about 30 seconds; tap it to select it.
- 3Check the device page: GPS and traffic should report as connected, and the satellite count should match what the Stratux web interface showed. If an AHRS board is fitted, attitude appears here too.
- 4Set the Stratux as the position source so Garmin Pilot navigates on the receiver's aviation-grade GPS instead of the tablet's own, and switch the traffic layer on in the map settings.
- 5Only with an AHRS board: enable synthetic vision in the map layer settings. Without the sensor the option stays empty, because nothing is sending attitude.
What you get in Europe - and what no Stratux can give you here
Most Garmin Pilot and Stratux guides are written for the USA, and the difference is not the app but the firmware. A Stratux has two SDR receivers: the first is always 1090 MHz, the second is tuned by the firmware build you installed - 868 MHz in the EU version for FLARM, OGN, ADS-L, FANET and PilotAware, or 978 MHz in the US version for UAT. Same hardware, one choice, and it decides which half of those American promises can reach your cockpit.
What a Stratux delivers here
- ADS-B traffic on 1090 MHz - airliners, most IFR traffic and every GA aircraft with ADS-B Out.
- With the EU firmware, the second SDR sits on 868 MHz: FLARM-compatible traffic, OGN, ADS-L, FANET and PilotAware - the gliders, paragliders and light aircraft that no 1090 MHz receiver ever sees. All of it reaches Garmin Pilot as GDL90 targets, so the app needs no idea these protocols exist.
- A GPS position and pressure altitude good enough to navigate on, independent of the tablet's internal receiver.
- Attitude for synthetic vision, if an AHRS sensor board is fitted.
What it cannot deliver in Europe
- FIS-B weather - NEXRAD, METARs over the air - and TIS-B traffic. Both ride on 978 MHz UAT, a US ground service nothing in Europe transmits, so a guide promising NEXRAD is describing American airspace.
- Traffic that is not transmitting. A Stratux shows what it hears: an aircraft with only a Mode A/C transponder, or no transponder at all, stays invisible. Keep looking outside.
- Weather and notams from the internet while you are on the Stratux WiFi - that connection has no route to the internet. The WiFi Direct guide keeps mobile data alive alongside it.
Which band does what, and how to put the right build on the card:Frequency guideInstall firmware
If something does not work
- Stratux never appears in the device list
- Check that the tablet is still on the stratux network - iOS and Android both like to jump back to a network with internet. On iOS, Garmin Pilot also needs Local Network permission (Settings - Privacy & Security - Local Network); without it the app cannot see the receiver at all. Grant it, then force-quit and reopen Garmin Pilot.
- The connection drops when the screen locks
- A locked tablet drops its WiFi to save power. Set auto-lock to never for flying, and keep the tablet on charge - a bright screen with WiFi and GPS running will outpace a small USB supply.
- Traffic arrives, but the position still comes from the tablet
- Garmin Pilot keeps its own GPS until the Stratux is set as the preferred position source. Set it on the device page, and make sure the app has location permission - on iOS it needs that even when the position comes from an external receiver.
- A second EFB app on the same tablet gets nothing
- GDL90 arrives on UDP port 4000, and some apps claim that port exclusively. If two EFBs are open at once, one of them may get the whole stream and the other nothing. Close the app you are not flying with.
- The device connects, but no targets show up at all
- That is a reception problem, not an app problem: check it on the Stratux status page rather than in Garmin Pilot. Both antennas screwed on and on the right connectors, both SDRs recognised, and the device somewhere with a view out - inside a metal hangar or low on the floor of the cockpit, there is nothing to hear.
Original source: Stratux EFB Configuration wiki (per-app settings, GDL90 on UDP 4000)
Related Technology Guides
Disclaimer
Stratux is not certified aviation equipment. It does not replace a transponder or relieve the pilot of traffic awareness responsibilities. Use as supplementary situational awareness only. Dross:Aviation assumes no responsibility or liability for the use of Stratux devices, firmware flashing, or hardware modifications. All DIY guides are provided without warranty: use at your own risk.