Add an AHRS or Pressure Altitude Sensor

Upgrade your Stratux (OGN) FLARM with an AHRS or pressure altitude sensor board

This section explains how to upgrade your current Stratux (OGN) FLARM with an additional AHRS (Attitude Heading Reference System) or pressure altitude sensor. AHRS can be used to show a synthetic horizon on your tablet or smartphone.

How to connect

  1. 1As shown below, connect your AHRS sensor board or pressure altitude sensor board to the Raspberry Pi's GPIO header pins (SDA, SCL, GND, 3V3). The board simply plugs onto the additional GPIO header pins.
  2. 2Configure the AHRS flight sensor in the Stratux web interface under Settings > AHRS. Stratux Web Interface guide.

Benefits

AHRS provides an artificial horizon, G-meter and turn-rate indication on compatible EFB apps; a pressure altitude sensor broadcasts accurate barometric altitude for traffic alerts.

Shop AHRS sensor boards

Power and USB load

Adding senders to a Raspberry Pi loads its shared USB budget (around 1,200 mA total). Two SDRs already draw most of it, and every T-Beam transmit burst adds a spike on top. On a Dual Pro the USB bus is pushed past its limit, so the weakest device drops. The classic symptom is a T-Beam that disconnects after a few minutes in flight.

Our latest AHRS sensor board revision is the only board that fixes the root cause: it keeps the sender power off the Pi's USB budget and smooths the current draw during transmit peaks, so two T-Beams and two SDRs run without dropouts, with no cable surgery and no external power mods. Just plug it in and fly.

Shop AHRS sensor boards

Instructions above are provided "as is" with no express or implied guarantee.