Add Pressure Altitude Sensor to T-Beam

Add a barometric pressure altitude sensor (BMP280) to a TTGO T-Beam (ESP32)

This section instructs how to enrich your Stratux (OGN) FLARM with a barometric pressure altitude sensor when using a TTGO T-Beam (ESP32) to send your aircraft's position to others. This is needed to broadcast your barometric pressure altitude rather than GPS altitude to other aircraft.

Barometric pressure altitude sensor (BMP280) to be soldered to pins "3V3", "GND", "22", "21".

Using BMP280 on T-Beam (Pin 3V3, GND, 22, 21)
How to add a pressure sensor to TTGO T-Beam (ESP32)

Wiring

  • VCC → 3V3 power
  • GND → GND
  • SCL → 22
  • SDA → 21

Original source: Stratux Pressure Sensor (BMP280) wiki