Add Altitude Sensor to softRF T-Motion

Add a barometric pressure altitude sensor (BMP280) to a softRF T-Motion (STM32)

This section instructs how to enrich your Stratux (OGN) FLARM with a barometric pressure altitude sensor when using a softRF T-Motion (STM32) to send your aircraft's position to others. This is needed to broadcast your barometric pressure altitude rather than GPS altitude to other aircraft.

Barometric pressure altitude sensor (BMP280) to be soldered to pins "3V3", "GND", "PB6", "PB7".

How to add barometric pressure altitude sensor (BMP280) to a softRF T-Motion

Wiring

  • VCC → 3V3 power
  • GND → GND
  • SCL → PB6
  • SDA → PB7

Original source: Stratux Pressure Sensor (BMP280) wiki